Showing entries 1 to 2
Displaying posts with tag: firmware (reset)
Some LSI 9211-8i issues on Windows and Linux
tl;dr:
Make sure you flash an LSI-9211 to IT firmware rev#14 to get it to work 
with Linux and SSD trim.  You may have to downgrade from newer firmware
to older firmware to get the card to work.



Finding a SATA III controller with more than one PCI-e lane
After a recent hardware issue I decided to upgrade my computer to use new Intel 520 120MB SSD drives in RAID for improved performance.  The motherboard I use (an ASUS Rampage III extreme) has a Marvel SATA III controller with two ports, but I discovered that it is connected via only a single PCI-e lane (each lane can do at most 400MB/sec*).  This means that it can't effectively support even a single Intel 520 because one device can saturate the SATA III bus (An Intel 520 is rated at up to 550MB/sec sequential write).

So I went on a quest for a new SATA 3 controller.   To Frys! I exclaimed.  But unfortunately, all the PCI-e 2.x SATA III …

[Read more]
Some LSI 9211-8i issues on Windows and Linux
tl;dr:
Make sure you flash an LSI-9211 to IT firmware rev#14 to get it to work 
with Linux and SSD trim.  You may have to downgrade from newer firmware
to older firmware to get the card to work.



Finding a SATA III controller with more than one PCI-e lane
After a recent hardware issue I decided to upgrade my computer to use new Intel 520 120MB SSD drives in RAID for improved performance.  The motherboard I use (an ASUS Rampage III extreme) has a Marvel SATA III controller with two ports, but I discovered that it is connected via only a single PCI-e lane (each lane can do at most 400MB/sec*).  This means that it can't effectively support even a single Intel 520 because one device can saturate the SATA III bus (An Intel 520 is rated at up to 550MB/sec sequential write).

So I went on a quest for a new SATA 3 controller.   To Frys! I exclaimed.  But unfortunately, all the PCI-e 2.x SATA III …

[Read more]
Showing entries 1 to 2