Home |  MySQL Buzz |  FAQ |  Feeds |  Submit your blog feed |  Feedback |  Archive |  Aggregate feed RSS 2.0 English Deutsch Español Français Italiano 日本語 Русский Português 中文
Testing the Micron P320h
+3 Vote Up -0 Vote Down

The Micron P320h SSD is an SLC-based PCIe solid-state storage device which claims to provide the highest read throughput of any server-grade SSD, and at Micron’s request, I recently took some time to put the card through its paces, and the numbers are indeed quite impressive.

For reference, the benchmarks for this device were performed primarily on a Dell R720 with 192GB of RAM and two Xeon E5-2660 processors that yield a total of 32 virtual cores. This is the same machine which was used in my previous benchmark run. A small handful of additional tests were also performed using the Cisco UCS C250. The operating system in use was CentOS 6.3, and for the sysbench fileIO tests, the EXT4 filesystem was used. The card itself is the 700GB model.

So let’s take a look at the data.

With the sysbench fileIO test in asynchronous mode, read performance is an extremely steady 3202MiB/sec with almost no deviation. Write performance is also both very strong and very steady, coming in at a bit over 1730MiB/sec with a standard deviation of a bit less than 13MiB/sec.

 

When we calculate in the fact that the block size in use here is 16KiB, these numbers equate to over 110,000 write IOPS and almost 205,000 read IOPS.

When we switch over to synchronous IO, we find that the card is quite capable of matching the asynchronous performance:

Synchronous read reaches peak capacity somewhere between 32 and 64 threads, and synchronous write tops out somewhere between 64 and 128 threads. The latency numbers are equally impressive; the next two graphs show 95th and 99th-percentile response time, but there really isn’t much difference between the two.

At 64 read threads, we reach peak performance with latency of roughly 0.5 milliseconds; and at 128 write threads we have maximum throughput with latency just over 3ms.

How well does it perform with MySQL? Exact results vary, depending upon the usual factors (read/write ratio, working set size, buffer pool size, etc.) but overall the card is extremely quick and handily outperforms the other cards that it was tested against. For example, in the graph below we compare the performance of the P320h on a standard TPCC-MySQL test to the original FusionIO and the Intel i910 with assorted buffer pool sizes:

 

And in this graph we look at the card’s performance on sysbench OLTP:

It is worth noting here that EXT4 outperforms XFS by a fairly significant margin. The approximate raw numbers, in tabular format, are:

-EXT4XFS13GiB BP22000750025GiB BP17000900050GiB BP210001100075GiB BP2500015000100GiB BP3100019000125GiB BP3600025000

In the final analysis, there may or may not be faster cards out there, but the Micron P320h is the fastest one that I have personally seen to date.

The post Testing the Micron P320h appeared first on MySQL Performance Blog.

Votes:

You must be logged in with a MySQL account to vote on Planet MySQL entries. More information on PlanetMySQL voting.

Planet MySQL © 1995, 2014, Oracle Corporation and/or its affiliates   Legal Policies | Your Privacy Rights | Terms of Use

Content reproduced on this site is the property of the respective copyright holders. It is not reviewed in advance by Oracle and does not necessarily represent the opinion of Oracle or any other party.